Snap-on Tools 1990's Logo Truck or Tool Box Decal 18" x 3½" White New Old Stock
$ 13.2
Description
This is a New Old Stock Snap-on® Tools 1990's Old Logo Truck or Tool Box White Decal 18" x 3½". This auction is for a pair (2) of these decals These were designed to be applied to the outside of the dealers truck or on a tool box. The white decals are very hard to get a good picture of because of the masking and transfer paper and are best used on colored surfaces. The last picture shows a red one installed on my overhead locker above my tool box. It will be rolled and mailed in a strong cardboard tube. Decals come in 1 piece: 1. Top layer is a transparent transfer tape. (Holds your decal or sticker together until it is applied) 2. Middle layer is your actual decal or sticker (It is sandwiched between the Application Tape and the Wax Backing) 3. Bottom layer is the paper backing. (protects the adhesive until the decal is ready to be applied) Application Tips: 1. Do not apply on extreme cold or hot Surfaces. Ideal temperature must be between 60°F & 90°F (room temperature). 2. Do not touch the adhesive backing, oils from your skin will prevent sticking. 3. Before applying decal make sure there is no wax, oily products or dust on the surface of vehicle. Application Instructions: 1. Rub the sticker to be sure the transfer tape is properly adhered to the sticker. 2. Clean and dry the desired area. 3. Remove the paper backing slowly making sure the sticker stays adhered to the transparent transfer tape. 4. Spray the area with 2% soap and 98% water. 5. Carefully position the sticker to the desired area. The water will allow the vinyl to be re-positioned. 6. Use a squeegee/credit card and rub the sticker from one side to the other, eliminating any air bubbles and water that is trapped underneath. Continue until the adhesive adheres to the vehicles surface. 7. Slowly remove the transfer tape, making sure no part of the sticker remains on the transfer tape. 8. You may use blow dryer to soften the adhesive some more and rub the sticker so it will adhere better. 9. Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker, but if not, a pin hole will allow the air out and become virtually invisible. 10. Wrap the vinyl around the edges and use a blow dryer to dry off the remaining excess water. Yes I will combine shipping on multiple purchases whenever it is possible check out my other items ! Be sure to add me to your favorites list ! Thanks for Looking and Good Luck Bidding Powered by SixBit's eCommerce Solution
